Setting the speaker impedance

Caution

If you are to use 6 ohm speakers, set “SP IMP.” to

“6Ω MIN” as follows BEFORE using this unit. 4 ohm speakers can be also used as the front speakers.

1Make sure this unit is turned off.

Refer to the right column for details.

2Press and hold CTONE CONTROL on the front panel and then press BMASTER ON/ OFF inward to the ON position to turn on this

unit.

This unit turns on, and the advanced setup menu appears in the front panel display.

TONE CONTROL While holding MASTER

down

ON OFF

3Rotate the DPROGRAM selector on the front panel to select “SP IMP.”.

“SP IMP.” and the current speaker impedance setting (“8Ω MIN”) appear in the front panel display.

4Press CTONE CONTROL on the front panel repeatedly to select “6Ω MIN”.

5Press BMASTER ON/OFF on the front panel to release it outward to the OFF position to save the new setting and turn off this unit.

Note

The setting you made is reflected next time you turn on this unit.

Connections

Turning this unit on and off

■Turning on this unit

Press BMASTER ON/OFF on the front panel inward to the ON position to turn on this unit.

When you turns on this unit by pressing BMASTER ON/OFF, the main zone is turned on.

y

When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound.

■Turning off this unit

Press BMASTER ON/OFF on the front panel again to release it outward to the OFF position to turn off this unit.

Notes

•AMAIN ZONE ON/OFF on the front panel as well as

HPOWER and GSTANDBY on the remote control are operational only when BMASTER ON/OFF is pressed inward to the ON position.

•As usual, we recommend using the standby mode to turn off this unit.

■Set the main zone to the standby mode

Press AMAIN ZONE ON/OFF

(or GSTANDBY) to set the main zone to the standby mode.

In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.

■Turning on the main zone from the standby mode

Press AMAIN ZONE ON/OFF (or HPOWER) to turn on the main zone.

y

•You can also turn on the main zone by pressing FSCENE (or FSCENE) buttons.

•When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound.

•These buttons are operational only when BMASTER ON/ OFF is pressed inward to the ON position.

PREPARATION

English

25 En