ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS

You can adjust the output level of each effect speaker 3 Press j / i to adjust the speaker output level.

(center, left and right rear and subwoofer) while listening• The control range for the center or left and right
to a music source.

 

 

rear speakers is from +10 dB to –10 dB.

 

 

Adjustment should be made with the remote control.

• The control range for the subwoofer is from 0 dB
to –20 dB.

 

 

1

3

 

 

 

2

Notes

• If the speaker output mode is set to NONE, the output level of that speaker cannot be adjusted.

• When you adjust the output level with LEVEL, the settings you made with the test tone will be changed.

1 Set the selector dial to the

AMP/TUN (or DSP/TUN) position.

2 Press LEVEL repeatedly to select the speaker(s) you want to adjust.

Each time you press LEVEL, the selected speaker changes and appears on the front panel display and on the video monitor as follows: center, right rear, left rear and subwoofer.

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the output level of the effect speakers you adjusted will return to the factory settings. If so, adjust the output level again.

Center speaker output level

Right rear speaker output level

Left rear speaker output level

Subwoofer output level

y

•Once you press LEVEL, you can also select the speaker(s) to be adjusted by pressing d. (Pressing uchanges the selection in the reverse order.)

44