Changing Parameter Settings

You can enjoy good quality sound with the factory-set parameters. Although you do not have to change the initial settings, you can change some of the parameters to better suit the input source or your listening room.

Adjustments should be made with the remote control.

y

•We recommend that you edit the parameter while using a video monitor. It is easier to see the video monitor than it is to see the front panel display.

3

2

1

4

 

5

3

 

1 Set the selector dial to the DSP/TUN (or
AMP/TUN) position.

or

2 Turn on the video monitor and press ON SCREEN repeatedly to select the full display mode.

3 Select a DSP program you want to adjust.

Program No. Program name (group)

P04 ROCK CONCERT

Cursor

INIT.DLY

15ms

 

LIVENESS

5

 

REV.TIME

 

1.6s

 

REV.DELAY

100ms

 

REV.LEVEL

7%

 

 

 

 

 

 

 

 

 

 

Parameters

Example of the ROCK CONCERT

SOUND FIELD PROGRAM PARAMETER EDITING

4 Press u/d to select the parameter.
5 Press j / i to change the parameter value.

y

•When you set the parameter to a value other than the factory- set value, an asterisk mark (*) appears by the parameter name on the video monitor

6 Repeat steps 3 to 5 above as necessary to change other program parameters.

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter value you edited will return to the factory setting. If so, edit the parameter value again.

Resetting a Parameter to the

Factory-set Value

■To reset some of the parameters to the factory-set values

Select the parameter you want to reset. Then press and hold jor iuntil the value temporarily stops at the factory-set value. The asterisk mark (*) by the parameter name disappears on the video monitor.

■To reset all of the parameters to the factory-set values

Use “9 PARAM. INI” on the SET MENU to reset all of the parameter values of all DSP programs within the selected group to the factory-set values (see page 41). This operation resets all of the parameter values of all DSP programs within that group to the factory-set values.

Notes

•The available parameters may be displayed on more than one OSD page for some of the programs. To scroll through pages, press u/d.

•You cannot change parameter values when “15 MEMORY GUARD” on the SET MENU is set to ON. If you want to change the parameter values, set “15 MEMORY GUARD” to OFF (see page 43).

INFORMATION

ADDITIONAL

 

 

English

61