Optimizing the speaker setting for your listening room (YPAO)
15Press 8ENTER to confirm your selection.
The top “SET MENU” screen appears in the OSD.
SET MENU
.;AUTO SETUP
;MANUAL SETUP
.A;SIGNAL INFO
[p]/[p]:Up/Down [ENTER]:Enter
16Press ISET MENU to exit from “SET MENU”.
y
If you change speakers, speaker positions, or the layout of your listening environment, run “AUTO SETUP” again to recalibrate your system.
■If an error screen appears
Press 8k / n / l / h to select “RETRY” or “EXIT” and then press 8ENTER.
The following display is an example when
ERROR
.
any function
>RETRY EXIT
[[]/[[]:Select [ENTER]:Enter
Choices: RETRY, EXIT
•Select “RETRY” to retry the “AUTO SETUP” procedure.
•Select “EXIT” to exit from the “AUTO SETUP” procedure.
y
If
■If “WARNING” appears
When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” appears in the top result display. Check the warning messages to correct your speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the “AUTO SETUP” procedure.
1Make sure the pointer is pointing at “WARNING” and then press 8ENTER to
display the detailed information about the warning.
The number on the right of “WARNING” indicates the number of warning messages.
AUTO
.WARNING(3)
RESULT
SP : 3/4/0.1
DIST: 14.0/17.0ft
LVL :
>SET CANCEL
[
]/[
]:Up/Down [ENTER]:Detail
2Press 8l / h repeatedly to toggle between the warning displays.
WARNING
Reverse Channel
FL
CENTER |
|
PL | PR |
SL | SR |
SBL | SBR |
[[]/[[]:Select
[ENTER]:Return
y
•For details about each warning message, see the “AUTO SETUP” section in “Troubleshooting” on page 120.
•When the corresponding warning message is not applicable to a speaker,
•If “SWFR: TOO LOUD” or “SWFR: TOO LOW” appears
in the
3Press 8ENTER to return to the top result
display.
