Yamaha RX-V863 owner manual 87 En, Speaker settings Aspeaker SET

1 BASIC MENU

Use this feature to manually adjust the basic speaker settings. Most of the “BASIC MENU” parameters are set automatically when you run the automatic setup.

1 BASIC MENU

. A)SPEAKER SET

B)SP LEVEL C)SP DISTANCE D)TEST TONE

[[ p Up/Down

[ENTER]: Enter

y

Set “TEST TONE” to “ON” to output the test tone for the “SPEAKER SET”, “SP LEVEL” and “SP DISTANCE”.

■Speaker settings A)SPEAKER SET

y

To select the desired parameter, press 8k/ nrepeatedly.

Extra speaker assignment EXTRA SP ASSIGN

Selects the function of the speakers connected to the EXTRA SP terminals.

XA)SPEAKER SET

X

XEXTRA SP ASSIGN

XZONE2 >FRONT B

XZONE B PRESENCE

XNONE

	X
	X
	X
	[	p
	XXXX[ZONE2 SET
	XXXX[p]/[Not[]:EnterXXXXXXXAvailable
	X
Choice		Descriptions
ZONE2	Select this setting when you use the Zone 2
	speakers (see page 107).
FRONT B	Select this setting when you use another front
	speaker system in the main zone (see page 43).
ZONE B	Select this setting when you use another front
	speaker system in another room (see page 43).
PRESENCE	Select this setting when you use the presence
	speakers (see page 13).
NONE	Select this setting when you do not use the
	EXTRA SP terminals.

Customizing this unit (MANUAL SETUP)

LFE/bass out LFE/BASS OUT

Use this feature to select the speakers that output the LFE (low-frequency effect) and the low-frequency signals.

A)SPEAKER SET

LFE/BASS OUT

SWFR FRONT >BOTH

LFE signals output

	Subwoofer(s) and speakers
Choice
	Subwoofer(s)	Front	Other
		speakers	speakers
BOTH	Output	No output	No output
SWFR	Output	No output	No output
FRONT	No output	Output	No output

Low-frequency signals output

	Subwoofer(s) and speakers
Choice
	Subwoofer(s)	Front	Other
		speakers	speakers
BOTH	*1	*2	*3
SWFR	*4	*3	*3
FRONT	No output	*1	*3

*1 Output(s) the low-frequency signals of the front channels and other speakers set to “SMALL”.

*2 Always output the low-frequency signals of the front channels.

*3 Output the low-frequency signals if the speakers are set to “LARGE”.

*4 Outputs the low-frequency signals of the speakers set to “SMALL” or “NONE”.

OPERATION ADVANCED

Notes

•This parameter shares the value with the “EXTRA SP ASSIGN” parameter in “AUTO SETUP” (see page 33).

•If you select “ON” in “BI-AMP” (see page 112), you cannot select “PRESENCE” or “ZONE2” in “EXTRA SP ASSIGN”.

•After changing the “EXTRA SP ASSIGN” setting, carry out “AUTO SETUP” again (see page 32).

English

87 En