Hookups

Connecting Speakers

This section explains how to connect speakers to this unit. After you finish connecting your speakers, use the SET MENU to change the signal output settings according to the number and size of the speakers in your configuration.

Before connecting any speaker cords, identify which terminals are for the right and left channels and also the + and –polarities. If you connect speakers with the wrong polarity (+ to –), this unit will not reproduce clear sound.

Preparations

Banana Plug

(Except for Singapore model)

■Using speaker cords

A speaker cord is actually a pair of insulated cables running side by side. One of the cables is colored or shaped differently, perhaps with a stripe, groove, or ridge. To make sure you always connect speakers with the correct polarity, determine the difference between the cables of your speaker cord, make a note of which cable you plan to use for which polarity (+ and –), and always connect the speaker cords consistently.

1Strip off 9 mm (3/8 in.) of an inch of insulation from the ends of the cables.

2Twist the exposed wires of the cable together to prevent short circuits.

3Loosen the terminal knob by turning it counterclockwise.

4Insert only the exposed portion of the cable into the slot in the side of the terminal, and tighten the terminal knob.

Note:

•If your speaker cords have banana plugs, tighten the terminal knob and insert the plug into the end of the terminal. (Except for Singapore model)

Caution:

•Connect the speaker cords with care to avoid creating a short circuit. If you turn on the power and there is a short circuit, this unit may be damaged even though the protection circuit automatically shuts off the power.

■About the qRF (AC-3) signal input jack <For China, Singapore, and General models only.>

If your LD player has an qRF (AC-3) signal output jack, connect it to the qRF (AC-3)input jack on this unit. For this connection, change SET MENU item 7D. COAXIAL IN (10) to “LD-RF”. If qRF (AC-3) and analog signals are input at the same time, priority is

given to the RF signals. When you want to reproduce qRF (AC-3) signals, set the input mode to “D.D. RF” using INPUT MODE.

Note:

• qRF (AC-3) signals cannot be output using the REC OUT selector. When you record sound or images from an LD player, be sure to connect the player to either the DIGITAL OPTICAL or analog AUDIO jacks.

Caution:

•Even if you connect an LD player with anqRF (AC-3) output jack to this unit, you cannot reproduce Dolby Digital sound from all LD discs. You must playback an LD disc encoded with Dolby Digital signals in order to take advantage of the Dolby Digital sound.

14