Getting StartedChecking the Package Contents

Check your package to make sure it has the following items.

 

 

R L

 

 

 

 

 

 

FM Antenna

Alkaline Batteries (3) (LR6)

Side Panel Sticker

AM Loop Antenna

(Australia and Singapore

 

 

models only)

 

 

 

 

Quick Reference Card

 

 

 

 

■ ✲❅❍❏▼❅ ✣❏■▼❒❏●

■ ✴✵✮✥✲ ❂◆▼▼❏■ ✈✴✵✮✥✲ ❁❒❅❁✉ ■ ✣✤ ❂◆▼▼❏■ ✈✣✤ ❁❒❅❁✉

 

 

 

 

■ ✭✤✏✴✡✰✥ ❂◆▼▼❏■ ✈✭✤ ❁❒❅❁✉ ■ ✣✤✍✲ ❂◆▼▼❏■ ✈✣✤✍✲ ❁❒❅❁✉

 

 

 

Remote Control

 

Power Cord

Power Cord

FM Antenna

✶✖✕✕✑✒✐

(U.S.A. and Canada

(Singapore model only)

(U.S.A., Canada, China,

Quick Reference Guide

models only)

 

and General models only)

 

 

 

When finding it difficult to fit this unit onto the shelf, remove the side panels after removing the screws tightened on the side panels. Put this sticker to cover the screw holes after tearing off the back side of the sticker.

Installing Batteries in the Remote Control

Insert the batteries in the correct direction by aligning the + and – marks on the batteries with the polarity illustrations (+and –) inside the battery compartment.

Change the batteries periodically. Do not use old batteries together with new ones.

Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

English

Reset button

Using the Remote Control
■About changing batteries

As the batteries wear out, the operating range of the remote control decreases and the TRANSMIT indicator does not flash or its light becomes dim. When you notice any of these conditions, change all of the batteries.

Notes:

•If the remote control is without batteries for more than 20 minutes, or if worn out batteries remain in the unit, the contents of the memory may be cleared.

If the memory is cleared, insert new batteries and reprogram any functions that may have been cleared.

•After you insert new batteries, be sure to push RESET in the battery compartment using a ball point pen or similar object before using the remote control. (This does not clear the contents of the memory.)

The remote control transmits a directional infrared beam. Be sure to aim the remote control directly at the remote control sensor on the main unit to operate. When the sensor is covered or there is a large object between the remote control and the main unit, the sensor cannot receive signals. The sensor may not be able to receive signals properly when it is exposed to direct sunlight or a strong artificial light (such as a fluorescent or strobe light). In this case, change the direction of the light or reposition the main unit to avoid direct lighting.

■ About handling the remote control

Approximately 6m

30° 30° (20 feet)

Handle the remote control with care.

Do not spill water or other liquids on the remote control. Do not drop the remote control.

Do not leave or store the remote control in the following types of conditions:

•high humidity or temperature such as near a heater, stove or bath; or

•dusty places; or

•in places subject to extremely low temperatures.

3