Yamaha RXV3000 CAUTION, We Want You Listening For A Lifetime, FCC INFORMATION (for US customers only)

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

EXAMPLE OF ANTENNA GROUNDING

MAST	ANTENNA
	LEAD IN
	WIRE
GROUND
CLAMP
	ANTENNA
	DISCHARGE UNIT
	(NEC SECTION 810–20)
ELECTRIC
SERVICE
EQUIPMENT	GROUNDING CONDUCTORS
	GROUNDING CONDUCTORS
	(NEC SECTION 810–21)
	GROUND CLAMPS
	POWER SERVICE GROUNDING
	ELECTRODE SYSTEM
	(NEC ART 250. PART H)
NEC – NATIONAL ELECTRICAL CODE

FCC INFORMATION (for US customers only)

	1. IMPORTANT NOTICE : DO NOT MODIFY THIS	Compliance with FCC regulations does not guarantee that
	UNIT!	interference will not occur in all installations. If this product
	This product, when installed as indicated in the instructions	is found to be the source of interference, which can be
	contained in this manual, meets FCC requirements.	determined by turning the unit “OFF” and “ON”, please try
	Modifications not expressly approved by Yamaha may void	to eliminate the problem by using one of the following
	your authority, granted by the FCC, to use the product.	measures:
	2. IMPORTANT : When connecting this product to	Relocate either this product or the device that is being
	accessories and/or another product use only high quality	affected by the interference.
	shielded cables. Cable/s supplied with this product MUST	Utilize power outlets that are on different branch (circuit
	be used. Follow all installation instructions. Failure to	Utilize power outlets that are on different branch (circuit
	be used. Follow all installation instructions. Failure to	breaker or fuse) circuits or install AC line filter/s.
	follow instructions could void your FCC authorization to use	breaker or fuse) circuits or install AC line filter/s.

	this product in the USA.	In the case of radio or TV interference, relocate/reorient the
	3. NOTE : This product has been tested and found to comply	antenna. If the antenna lead-in is 300 ohm ribbon lead,
	3. NOTE : This product has been tested and found to comply	change the lead-in to coaxial type cable.
	with the requirements listed in FCC Regulations, Part 15 for	change the lead-in to coaxial type cable.

	Class “B” digital devices. Compliance with these	If these corrective measures do not produce satisfactory
	requirements provides a reasonable level of assurance that	results, please contact the local retailer authorized to
	your use of this product in a residential environment will not	distribute this type of product. If you can not locate the
	result in harmful interference with other electronic devices.	appropriate retailer, please contact Yamaha Electronics
	This equipment generates/uses radio frequencies and, if not	Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA
	This equipment generates/uses radio frequencies and, if not	90620.
	installed and used according to the instructions found in the	90620.

	users manual, may cause interference harmful to the	The above statements apply ONLY to those products
	operation of other electronic devices.	distributed by Yamaha Corporation of America or its
		subsidiaries.

We Want You Listening For A Lifetime

YAMAHA and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion – and, most importantly, without affecting your sensitive hearing.

Since hearing damage from loud sounds is often undetectable until it is too late, YAMAHA and the Electronic Industries Association’s Consumer Electronics Group recommend you to avoid prolonged exposure from excessive volume levels.

CAUTION