OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL
Setting the manufacturer code for your TV, VCR or cable TV tuner/satellite tuner on the remote control allows you to operate not only the
Notes
•Remote control of some component may not be possible depending on the model and the year of make even though its manufacturer is listed on page i (at the end of this manual).
•Depending on the model, some components from other manufacturers cannot be controlled, or only limited functions can be controlled, even though the proper manufacturer code has been set. If you encounter this problem, please use the remote control supplied with the component.
•Setting the manufacture code can not be performed if your component to be controlled does not support remote control operation.
Setting the Manufacturer Code
4 | ON/OFF | Transmission | |
EFFECT | indicator | ||
| |||
| VS10 TV VCR CBL | 1 |
| CH |
|
| 2 |
– VOL |
| VOL | + | |
| CH |
|
| |
| SET |
|
|
|
MUTE | DSP | AV |
|
|
| MEMORY |
|
|
|
1 2 3
4 | 5 | 6 | 3 |
| |||
7 | 8 | 9 |
|
MENU
–+
LAST 0 ENTER
SUBWOOFERSUBWOOFER
– TEST+
NIGHT MODE
1 Press the remote control selector button (TV,
VCR or CBL) for which the manufacturer code is to be set.
The signals for controlling the control center have already been set for the VS10 button so that only the manufacturer code for the TV, VCR or CBL needs to be set. A manufacturer code of the TV, VCR or cable TV tuner/satellite tuner can be set for the TV, VCR or CBL button respectively.
TV VCR CBL
2 Hold down SET and press CHg until the transmission indicator lights.
The indicator will light.
CH
3 While the transmission indicator is lit, enter |
| ||
the |
| ||
component to be controlled using the numeric | REMOTE | ||
buttons. |
| ||
|
| ||
|
| The indicator will go out. |
|
1 | 2 | 3 | CONTROL |
4 | 5 | 6 | |
7 | 8 | 9 |
|
| 0 |
|
|
Enter the code surely. The transmission indicator goes out when the code is set properly. (The code has not been set properly if the indicator flashes and then goes out.)
Refer to the list of manufacturer codes on page i (at the end of this manual).
4 Press p and check that the component to be controlled turns on and off.
English
27