INSTALLATION
Depending on room conditions, the control center can be installed vertically or horizontally.
Precautions before installation
•Do not touch the adhesive surface after peeling off the pad as this will weaken its adhesive strength.
•Thoroughly wipe clean the surface where the pad is to be applied. Note that adhesive strength is weakened if the surface is dusty, oily or wet.
Installing the Control Center Horizontally
Apply the four supplied bottom pads to the bottom of the control center.
Peel off the seals of the bottom pads and apply to the four indented parts (screwed parts) on the bottom of the control center.
PREPARATION
Apply to the indented part.
Peel off the seal.
Bottom pad
Bottom panel
CAUTIONS
•Be sure to use the bottom pads when installing the control center horizontally. Otherwise, the front door of the control center cannot open.
•Be sure to apply the bottom pads to the indented parts (screwed parts) on the bottom panel. Do not apply them to the indented parts on the top of the control center.
English
7
