INSTALLATION
Installing the Control Center Vertically
Apply the two supplied side pads to the side of the control center and attach to the supplied supporting stand.
1 Peel off the seals of the side pads and apply to the two indented parts (near to the front panel) on the left side of the control center.
Peel off the seal.
Front panel
Side pad 
Apply to the indented part.
2 Attach the control center with the pads applied side facing down to the supporting stand as shown in the illustration below.
Front panel
Bottom panel
Rear panel
Apply to the indented part.
Lift in this direction.
A supporting stand
Note
• Using only the supporting stand makes the control center unstable and the front door cannot open. Be sure to use the side pads as well.
CAUTIONS
•Be sure to place the control center with the left side down.
•When installing the control center vertically on a high place such as on a shelf, do not place close to the edge.
8
