Maintenance and care

(1)Remove all of the battery caps.

(2)If the electrolyte level is low, add distilled water to raise it to the specified level.

(3)Set the charging rate to 1.9 ampere and charge the battery slowly until the explo- sive gases are discharged vigorously from the battery cells.

To install the battery:

(1)Place the battery in the battery compart- ment and connect the battery leads to the battery terminals.

(2)Connect the breather hose to the battery.

(3)Secure the battery in place.

needs to be adjusted, have a Yamaha dealer service the watercraft.

ECJ00220

CAUTION:

Do not attempt to adjust the fuel injection system. If the settings are disturbed by someone who does not have the necessary technical knowledge, poor engine performance and damage may result.

EJU34500

Checking the trolling speed

(1)Place the watercraft in the water.

(2)Start the engine and warm it up. Use the tachometer in the multifunction informa- tion center to check the trolling speed.

Trolling speed: 1650 ±50 r/min

If the trolling speed is out of specification, have a Yamaha dealer service the watercraft.

1Positive (+) battery terminal: Red lead

2Negative (–) battery terminal: Black lead

3Breather hose

EWJ00400

WARNING

Be sure to connect the breather hose to the battery. Fire or explosion could result if the breather hose is damaged, obstruct- ed, or not connected properly.

ECJ00260

CAUTION:

After installation, make sure that the battery leads are properly connected to the battery terminals.

EJU34490

Fuel injection system

The fuel injection system was set at the Yamaha factory. If the fuel injection system

80