E

 

 

 

 

 

EMU00949

 

 

 

 

 

 

 

 

 

 

Electric Start Model

 

 

 

 

 

7)

Turn the main switch to “START”,

 

 

ON

START

 

 

OFF

 

and hold it for a maximum of 5 sec-

 

 

 

 

 

 

 

 

 

 

 

 

onds.

 

 

 

 

 

8)

Immediately after the engine starts,

 

 

 

 

 

 

release the main switch to return it to

 

 

 

 

 

 

“ON”.

701022 cC

8Do not turn the main switch to “START” when the engine is running.

8Do not keep the starter-motor turning for more than 5 seconds. The battery will rapidly become exhausted and it will be impossible for it to start the engine. If the engine does not start within 5 seconds, return the main switch to “ON”, wait 10 seconds, and then crank the engine again.

EMU01198

WARMING UP ENGINE

1) Before beginning operation, allow the engine to warm up at idling speed for 3 minutes. (Failure to do this will shorten engine life.)

2) Check for a steady flow of water from the cooling-water pilot hole.

cC

A continuous flow of water from the pilot hole shows that the water pump is pumping water through the cooling pas- sages. If water is not flowing out of the pilot hole at all times while the engine is running, do not continue to run the engine. Overheating and serious damage could occur. Stop the engine and check to see if the water inlet on the lower casing is blocked. If the problem cannot be

309034

found and corrected, consult your Yamaha dealer.

3-13