MANUAL SETUP
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of sound beams for each channel. By adjusting the horizontal angle of the sound beams, you can optimize the sound beam paths. A test tone is automatically output.
( ) | (+) |
(+) | ( ) |
Choices: L90° to R90°
Adjust toward L (left) to move the direction of the output to the left and adjust toward R (right) to move it to the right.
a)HORIZONTAL ANGLE 1/5
|
| 5 beam |
Front L | L90 | R90 |
L65deg
*
0(deg)
[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return
VERTICAL ANGLE (Vertical angle)
Use to adjust the vertical angle of sound beams for each speaker. By altering the beam path, you can optimize sound beam angles.
Choices:
Initial setting: 0°
•Adjust toward – (minus) to move the angle downward.
•Adjust toward + (plus) to move the angle upward.
b)VERTICAL ANGLE 1/5
| 5 beam | |
Front L | (+) |
|
0deg. | ||
|
| |
|
|
|
[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return
BEAM TRAVEL LENGTH (Beam travel length)
A certain amount of delay must be applied to the sound from each channel so that all sounds can arrive at the listening position at the same time. This menu sets the distance that sound beams travel after being output and reflected off the wall until they arrive at the listening position and adjusts the delay applied to the respective channel.
The lines in the illustration below indicate the distance.
Choices: 0.3 m to 24.0 m (1.0 ft to 80.0 ft)
•Front L adjusts the distance the front left channel sound beams travel.
•Front R adjusts the distance the front right channel sound beams travel.
•Center adjusts the distance the center channel sound beams travel.
•Surround L adjusts the distance the surround left channel sound beams travel.
•Surround R adjusts the distance the surround right channel sound beams travel.
c)BEAM TRAVEL LENGTH5 beam
. Front L;;;;;;;6.0m Front R;;;;;;;6.0m Center;;;;;;;;2.5m Surround L;;;;9.1m Surround R;;;;9.1m
[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return
y
We recommend that you use the setting optimized by AUTO SETUP (see page 37). Adjust this parameter only when you changed HORIZONTAL ANGLE (see page 80).