•Select ANGLE TO WALL OR CORNER if this unit is installed in the corner of your listening room. Adjust the width and length of your listening room as well as the distance of the listening position from this unit.
Listening position from the unit
Room width
MANUAL SETUP
■BEAM ADJUSTMENT (Beam adjustment)Use to manually adjust the various sound beam settings. We recommend that you select 5 Beam as the beam mode before adjusting these parameters (see page 44).
Notes
•When INSTALLED POSITION is adjusted in MANUAL SETUP (see page 58), the factory default value is automatically set for this parameter except Center in FOCAL LENGTH (see page 60).
•Depending on the beam mode settings (see pages 44 and 50), some channel positions may not be available for selection. In this case, “–
Room length
Choices for the room width and length:
2.0 m to 12.0 m (6.5 ft to 40.0 ft)
Choices for the listening position from this unit: 1.8 m to 9.0 m (6.0 ft to 30.0 ft)
B)BEAM ADJUSTMENT
. a)HORIZONTAL ANGLE b)BEAM TRAVEL LENGTH c)FOCAL LENGTH d)TREBLE GAIN
[p]/[p]:Up/Down [ENTER]:Enter
| A)SETTING PARAMETERS 2/3 | ||
|
|
|
|
|
|
| |
Room width and |
|
| |
| [ 5.4m ] |
| |
length |
|
| |
|
| ||
|
|
| |
| [p]/[p]:Up/Down [p]/[p]:Sel | ||
|
| [ENTER]:Return | |
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of sound beams for each channel. By adjusting the horizontal angle of the sound beams, you can optimize the sound beam paths. A test tone is automatically output.
| A)SETTING PARAMETERS 3/3 | |
Listening | \ | |
[ 2.5m ] | ||
position from the | ||
\ | ||
unit |
| |
| [p]/[p]:Up/Down [p]/[p]:Sel | |
| [ENTER]:Return |
Note
When you set the INSTALLED POSITION parameter in MANUAL SETUP (see page 58), the parameters newly set for the width and length of your listening room are automatically set as the factory default value.
( ) | (+) |
(+) | ( ) |
Choices: L90° to R90°
Adjust toward L (left) to move the direction of the output to the left and adjust toward R (right) to move it to the right.
a)HORIZONTAL ANGLE 1/5
|
| 5 beam |
Front L | L90 | R90 |
L65deg
*
0(deg)
[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return
OPERATION | ADVANCED |
|
|
English