Using the system memory
You can save the current beam and sound settings in the system memory of this unit. It is handy to save certain settings according to the varying conditions of your listening environment. For example, if there are curtains in the path of sound beams, the effectiveness of the sound beams will vary depending on whether the curtains are open or closed.
y
•If there are curtains in your listening room, we recommend following the procedure below.
1.While the curtains are open, run “BEAM+SOUND OPTIMZ” (page 16) and then save the settings to “MEMORY1”.
2.While the curtains are closed, run “SOUND OPTIMZ ONLY” (page 16) and then save the settings to “MEMORY2”.
Saving settings |
| 5 Press GENTER. | |
|
| The current beam and sound settings are saved to the | |
| |||
|
| selected memory number. | |
| 1 Press ISETUP. | |||
|
|
Changing OSD
language
AUTO SETUP (IntelliBeam)
Using the system
memory
PREPARATION INTRODUCTION
SET MENU
.;MEMORY ;AUTO SETUP ;MANUAL SETUP
;SOUND SET MENU ;SOUND OUT MENU ;INPUT MENU ;DISPLAY MENU [p]/[p]:Up/Down [ENTER]:Enter
MEMORY1 Saving...
1)LOAD
2)SAVE
[p]/[p]:Up/Down [ENTER]:Enter
3Press G
/ 
to select “SAVE” and then press GENTER.2)MEMORY SAVE
a)MEMORY1
b)MEMORY2
c)MEMORY3
[p]/[p]:Up/Down [ENTER]:Enter
4 Press G
/ 
to select the desired memory number and then press GENTER.Loading settings
1Press ISETUP.
SET MENU
.;MEMORY ;AUTO SETUP ;MANUAL SETUP
;SOUND SET MENU ;SOUND OUT MENU ;INPUT MENU ;DISPLAY MENU [p]/[p]:Up/Down [ENTER]:Enter
2Press GENTER.
A)MEMORY
1)LOAD
2)SAVE
[p]/[p]:Up/Down [ENTER]:Enter
3Press GENTER again.FEATURES PLAYBACK
SETTINGS
2)MEMORY SAVE
MEMORY1 Save Now?
[ENTER]:Enter
y
•If system settings are already stored in the selected memory number, this unit overwrites the old settings.
a)MEMORY1
b)MEMORY2
c)MEMORY3
[p]/[p]:Up/Down [ENTER]:Enter
APPENDIX