Changing OSD language

You can select an OSD language among English, German, French, Spanish, Italian, Dutch and Russian. Before operating the following steps, select this unit as the video input on your TV.

INTRODUCTION

1Press and hold ISETUP until the “LANGUAGE SETUP” menu appears on your TV.3)LANGUAGE SETUP

. ENGLISH

DEUTSCH

Francais

ESPANOL

ITALIANO NEDERLANDS

[p]/[p]:Up/Down [ENTER]:Enter

2Press G / to select the desired language and then press GENTER.

Choices: ENGLISH (English), DEUTSCH (German), Français (French), ESPAÑOL (Spanish), ITALIANO (Italian), NEDERLANDS (Dutch), Русский (Russian)

Initial setting: ENGLISH (English)

3To exit from the menu, press ISETUP.
Changing OSDlanguage

AUTO SETUP (IntelliBeam)

Using the systemmemory
PREPARATION

AUTO SETUP (IntelliBeam)

This unit creates a sound field by reflecting sound beams off the walls of your listening room and by broadening the cohesion of all the channels. Just as you would arrange the speaker position of other audio systems, you need to set the beam angle to enjoy the best possible sound from this unit.

Notes

•After you have completed the AUTO SETUP procedure, be sure to disconnect the IntelliBeam microphone.

•The IntelliBeam microphone is sensitive to heat.

–Keep the IntelliBeam microphone away from direct sunlight.

–Do not place the IntelliBeam microphone on top of this unit.

•You cannot use the AUTO SETUP when “PREOUT” is selected in “SOUND OUT” (page 38).

•You cannot run the AUTO SETUP while playing back the iPod/iPhone by using PDX-50TX. To run the AUTO SETUP, stop playback and then disconnect the iPod/iPhone from PDX-50TX. About PDX-50TX, refer to “Safety and Accessory Information” (separate booklet).

Installing the IntelliBeam

y

• Use the supplied cardboard microphone stand or a tripod

microphone

to place the IntelliBeam microphone at the same height as

 

 

your ears would be when you are seated.

 

FEATURES PLAYBACK

Follow the procedure below to connect the IntelliBeam microphone to this unit and place it in a proper location.

IntelliBeam microphone

1Connect the supplied IntelliBeam microphone to the INTELLIBEAM MIC jack on the front panel.

Center height of

this unit

Cardboard microphone stand

1.8m (6.0 ft) or more

Upper limit

Within 1 m (3.3 ft)

Within 1 m (3.3 ft)

Listening position

Lower limit

SETTINGS

INTELLIBEAM MIC

2Place the IntelliBeam microphone on a flat level surface at your normal listening position.

Place the IntelliBeam microphone on the extended center line of this unit and 1.8 m (6.0 ft) or more away from it. Also, make sure place the IntelliBeam microphone within 1 m (3.3 ft) upper or lower from the center height of this unit.

Center line

IntelliBeam

Cardboard microphone microphone

stand

APPENDIX

15 En