Z Microsystems 15 manual Final Adjustments of the Command Console

Install Console

FINAL ADJUSTMENTS OF THE COMMAND CONSOLE

Loosen the screws on each of the front Z-Lock mounts.

Slide the Console partially out.

Use a flathead screw driver to slightly move the Z-Locks out away from the Console.

Tighten all the screws on the front Z-Lock mounts.

Slide the Console in and out to see if it moves smoothly.

Go back to the rear of the rack and fully tighten the side rail screws.

Note: A wrench may be necessary to hold the nut on the other side.

10

Doc# 27-0002UM Issued 7/99 Rev. 1.2