Zanussi FL 1014 V1 instruction manual Installation, Unpacking, Positioning

INSTALLATION

Unpacking

All transit bolts and packing must be removed before using the appliance.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

1.Using a spanner, unscrew and remove the rear right-hand bolt and lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.

2.Remove the polystyrene block from the bottom of the machine and release the two plastic bags by removing the adhesive strip.

3.Carefully remove the right-hand bag (1) then the left-hand bag (2) by pulling them towards the centre of the machine.

4.Set the machine upright and remove the two remaining bolts from the back.

5.Pull out the three plastic spacers from the holes into which the bolts were fitted.

6.Plug the open holes with the plugs which you will find at the back of the appliance.

P0255

P0234

P0256

ENGLISH

2	1
P0233

P0020

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

After having levelled the machine, tighten the lock nuts.

P0254

P0509

25