Zebra Technologies DA402 Peel-OffMode (optional)

Peel-Off Mode (optional)

1.Unlatch the top cover by pulling the two green release levers toward you (refer to Figure 8). Then, lift the top cover to expose the media compartment.

Release

Lever

Release

Lever

Figure 8

Contents

User's Guide Proprietary Statement Product Improvements FCC Compliance Statement Canadian DOC Compliance Statement Liability Disclaimer Page Page Contents Page Introduction Hello What’s in the Box Unpacking and Inspection Reporting Damage DC Power Supply Printer Overview Getting Ready to Print Loading the Media Tear-OffMode Page Page Page Peel-OffMode (optional) always Page Page Page Cutter Mode (optional) Page Page Fanfold Media Auto Calibration Operator Controls Power Switch Feed Button Status LED Printing a Test Label Hooking Up the Printer and Computer Serial (RS-232)Interface Requirements Parallel Interface Requirements Serial and Parallel Cabling Requirements Communicating with the Printer Via the Serial Port Via the Parallel Port Using ZPL Adjusting the Print Width Adjusting the Print Darkness Adjusting the Print Speed Page Troubleshooting What the Status LED is Telling You RESOLUTIONS: Print Quality Problems Page Manual Calibration Troubleshooting Tests Printing a Configuration Label Recalibration Resetting the Factory Default Values Communications Diagnostics Feed Button Modes Page Maintenance Cleaning Lubrication Page Parts List Replacing the Printhead Removing the Printhead Page Installing the Printhead Page Page Specifications Printing Specifications Label/Tag Specifications Font/Bar Code Specifications Physical/Environmental/Electrical Specifications Agency Approvals Options Serial (RS-232)Connector Technical Information Interconnecting to DTE Devices Interconnecting to DCE Devices Connecting the Printer to a DTE Device DB-25S DB-9P to DTE Device (PC) to Printer Connecting the Printer to a DCE Device to DCE Device Parallel Interface Technical Information Index