2.Separate and hold open the media hangers (refer to Figure 9).

3.Place the media roll onto the media hangers, making sure it is tightly wound (refer to Figure 10).

4.Open the peel-off unit by pulling down on its textured top surface (refer to Figure 11).

5.Activate the peel-off unit by moving the peel-off switch to the left (refer to Figure 11 inset).

NOTE: When not operating the printer in peel-off mode, always deactivate the peel-off unit by moving the peel-off switch to the right.

6.Remove approximately 6” (152 mm) of labels from the label backing.

Media

Hanger

Media

Hanger

Figure 9

10