Fanfold Media

Fanfold media loads from the outside of the printer. Refer to Figure 18.

1.Thread the media through the access slot in the back of the printer.

2.Separate and hold open the media hangers.

3.Lock the media hangers in position by tightening the screw located on the right media hanger.

CAUTION: Do not overtighten the screw! Overtightening could pierce the case and damage the printer’s electronics!

4.Thread the media through the media guides.

NOTE: If the media guides must be changed to accommodate the width of the media, turn the green media guide adjuster. Media guides should just touch, but not restrict, the edges of the media.

5.Close the top cover and turn on the printer or press the feed button if the printer is already on (see “Auto Calibration” on page 18 for more information).

Media

Hangers

Lock-down

Screw

Media

Guide

Adjuster

Access

Media

Slot

Guides

Figure 18

17