Printing a Test Label

To print a test label:

19.Turn off the printer.

20.Press and hold the CANCEL key while turning on the printer.

A configuration label, which shows the printer’s currently stored parameters, will print (similar to the one shown in Figure 11).

PULSE MODE

START PRINT SIG

FEED MODE

RESYNCH MODE

ENABLED

RIBBON LOW MODE

DISABLED

REPRINT MODE

1P1

4096

NONE 1536

hfDep: Version 1

RFID VERSION

2000-05-17 12:27:15 TIME STAMP

Figure 11

If you encounter any problems while you are configuring or calibrating the printer or printing a test label, refer to Troubleshooting, which starts on page 79. Otherwise, refer to Establishing Communication on page 25 to set up the communication parameters.

Zebra R-140 User’s Guide

23