CANCEL Key Self Test

This self test prints a listing of the configuration parameters currently stored in the printer’s memory. See Figure 31 (depending on the options ordered, your label may look different).

1.Turn the printer off.

2.Press and hold the CANCEL key while turning on the power.

The configuration may be changed either temporarily (for specific label formats or ribbon and label stock) or permanently (by saving the new parameters in memory). Saving new parameters occurs whenever a calibration procedure is performed. Refer to page 19 for further information about the configuration procedure.

PULSE MODE

START PRINT SIG

FEED MODE

RESYNCH MODE

ENABLED

RIBBON LOW MODE

DISABLED

REPRINT MODE

1P1

4096

NONE 1536

hfDep: Version 1

RFID VERSION

2000-05-17 12:27:15 TIME STAMP

Figure 31

88

Zebra R-140 User’s Guide