Chapter 38 System Remote Management

38.8.3 SNMP Commands

The following table describes the commands available for SNMP. You must use the configure terminal command to enter the configuration mode before you can use these commands.

Table 176 Command Summary: SNMP

COMMAND

DESCRIPTION

[no] snmp-server

Allows SNMP access to the ZyWALL. The no command disables

 

SNMP access to the ZyWALL.

[no] snmp-server community community_string

Enters up to 64 characters to set the password for read-only

{rorw}

(ro) or read-write (rw) access. The no command resets the

 

password for read-only (ro) or read-write (rw) access to the

 

default.

[no] snmp-server contact description

Sets the contact information (of up to 60 characters) for the

 

person in charge of the ZyWALL. The no command removes the

 

contact information for the person in charge of the ZyWALL.

[no] snmp-server enable {informstraps}

Enables all SNMP notifications (informs or traps). The no

 

command disables all SNMP notifications (informs or traps).

[no] snmp-server host {w.x.y.z}

Sets the IPv4 or IPv6 address of the host that receives the

[community_string]

SNMP notifications. The no command removes the host that

 

receives the SNMP notifications.

[no] snmp-server location description

Sets the geographic location (of up to 60 characters) for the

 

ZyWALL. The no command removes the geographic location for

 

the ZyWALL.

[no] snmp-server port <1..65535>

Sets the SNMP service port number. The no command resets

 

the SNMP service port number to the factory default (161).

snmp-server rule {rule_numberappendinsert

Sets a service control rule for SNMP service.

rule_number} access-group {ALLaddress_object}

address_object: The name of the IP address (group) object.

zone {ALLzone_object} action {acceptdeny}

You may use 1-31 alphanumeric characters, underscores(_), or

 

 

dashes (-), but the first character cannot be a number. This

 

value is case-sensitive.

 

zone_object: The name of the zone. For the ZyWALL USG 300

 

and above, use up to 31 characters (a-zA-Z0-9_-). The name

 

cannot start with a number. This value is case-sensitive.

 

The ZyWALL USG 200 and lower models use pre-defined zone

 

names like DMZ, LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and

 

WAN.

 

 

snmp-server rule move rule_number to rule_number

Changes the index number of a service control rule.

no snmp-server rule rule_number

Deletes a service control rule for SNMP service.

show snmp status

Displays SNMP Settings.

38.8.4 SNMP Commands Examples

The following command sets a service control rule that allowed the computers with the IP addresses matching the specified address object to access the specified zone using SNMP service.

Router# configure terminal

Router(config)# snmp-server rule 11 access-group Example zone WAN action accept

 

293

ZyWALL (ZLD) CLI Reference Guide