Kodak Kodak 10/100 Network Interface Card, 3H0610 manual ConÞgure the print servers, if necessary

Kodak 10/100 NIC Introduction and Configuration

NIC ConÞguration Software

¥Windows: The NIC may be conÞgured from Windows-based platforms using NIC FastManage, NBMon or Telnet utilities. Refer to the Windows FastManage Utility chapter.

¥Macintosh: The NIC may be conÞgured from Macintosh-based platforms using NIC LaserWriter utilities. Refer to the Apple Macintosh - Laserwriter Utilities section. Telnet may also be used.

¥Unix: Use Telnet utilities.

¥Telnet: The NIC may be conÞgured from any platform supporting TCP/ IP via TELNET utilities after an IP address has been established. Refer to Appendix A, Telnet.

IMPORTANT: This 10/100 NIC is configurable ONLY by using remote configuration utilities listed above. Use of the front control panel and corresponding test page is not pertinent to this NIC.

Step 5: ConÞgure the print servers, if necessary

Determine whether server print queues will be used and conÞgure the appropriate servers.

Chapter 4 describes how to conÞgure Novell servers.

Procedures for conÞguring Windows NT servers are identical to procedures for conÞguring Windows NT workstations with the exception of ÒsharingÓ the printer. Refer to Windows NT chapters.

Step 6: ConÞgure the printer on workstations

Determine the printer modes (PostScript and raster) that will be used. Install the PostScript and raster printer software.

PostScript mode: PostScript printer drivers or PPDs must be installed on each platform that prints to the printer.

I

N T R O D U C T I O N

July 1998 1-9