Kodak Kodak 10/100 Network Interface Card, 3H0610 manual General Messages Cause Solution

General Messages

Message	Cause	Solution
Bad status from target	Appears when the	The Þrmware on the agent
device: <n>. Press	SNMP agent on device	does not match with the
CANCEL to exit	returns a	version of the Manager
program	NO_SUCH_NAME for a	software. Upgrade the agent
	particular OID	Þrmware and the
		FastManage Software
		Package.
Unable to open SNMP	Usually appears if the IP	Restart Windows.
Session	stack on the manager
	has died
Bitmap Init Error	Application is not able to	The FastManage installation
	Þnd the bitmap	may be bad. Reinstall.
Unable to load	File NPAPI.DLL could	Put the Þle NPAPI.DLL in the
NPAPI.DLL	not be found	path.
Unable to load	File NPSNMP.DLL could	¥ Put the Þle NPSNMP.DLL in
NPSNMP.DLL	not be found	the path.
		¥ Set NetBeui as a default
		using the Network Control
		Panel.
WINSNMP Error (%ld)	Appears when the	Use the PING application to
sending%s packet	manager is not able to	Þnd out if the agent device is
	send a WINSNMP	reachable. If yes, restart
	packet. Sometimes	Windows. If not, power cycle
	occurs due to an SNMP	the device and try again.
	agent in the device that
	crashed.

3.11.2 IP Address Validation Messages

The following table displays messages that you may see when entering an IP address:

IP Address Validation Messages

Message	Solution
More than 3 dots exist in the address or No	A valid IP address is of the form
characters present between dots or Invalid	a.b.c.d, where a.b.c.d can vary
character in IP Address or The address	from 0 to 255. For example,
contains one Þeld with value more than 255.	193.25.86.214
Not all Þelds are deÞned.