Husqvarna 966781601, 525 RS manual Assembly, Fitting the loop handle 524 L, 525 LST, 525 RJD

Page 12

ASSEMBLY

Fitting the loop handle (524 L, 525 LST, 525 RJD)

•Clip the loop handle onto the shaft. Note that the loop handle must be ﬁtted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle. Fit the nut, knob and screw. Do not overtighten.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt.

Fitting the handlebar (525 RS)

•Remove the screw at the rear of the throttle handle.

•Slide the throttle handle onto the right side of the handlebar, (see diagram).

•Align the screw hole in the throttle handle with the hole in the handlebar.

•Reﬁt the screw in the hole in the rear of the throttle handle.

•Screw the screw through the handle and handlebar. Tighten it.

•Unscrew the knob from the handlebar mounting.

•Position the handlebar as shown. Fit the mounting components and tighten the knob lightly.

•Put on the harness and hang the machine from the support hook. Now make a ﬁnal adjustment so that the machine is in a comfortable working position when it hangs from the harness.

12 – English

Image 12

Contents 524 L 525 LST RJD 525 RS KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system Quick release MufﬂerCutting equipment Locking nutCutting equipment Sharpening grass knifes and grass blades Trimmer headAssembly Fitting the loop handle 524 L, 525 LST, 525 RJDFitting the handlebar 525 RS Assembly Assembling the cutting equipmentAssembling and dismantling the two-piece shaft 525 RJD Fitting the trimmer guard and trimmer headAdjusting the harness and brush cutter Fitting a blade guard, grass blade and grass cutterDismantling Standard harness Spreading the load on your shouldersCorrect height Correct balanceFuel safety Fuel HandlingFuel Fueling MixingMufﬂer gets very hot during and after Use. This also applies during idling. BeStarting and Stopping Check before startingStarting and stopping StartingFor throttle handles with a start throttle lock StoppingBasic safety rules Working TechniquesGeneral working instructions Grass clearing using a grass blade Basic working techniquesGrass trimming with a trimmer head Cutting SweepingMaintenance Basic settingAdjustment of the idle speed CarburettorAdjusting the start throttle speed MufﬂerCooling system Spark plugTwo-piece shaft 525 RJD Air ﬁlterCleaning the air ﬁlter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataTechnical Data Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Alloy Original instructions 1155734-28