Husqvarna 525 RJD, 524 L, 525 LST Fitting a blade guard, grass blade and grass cutter, Dismantling

Page 14

ASSEMBLY

Dismantling

•Loosen the coupling by turning the knob (at least 3 times).

Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

C

Fitting a blade guard, grass blade and grass cutter

G

F

E

D

A	B

C

•Hook the blade guard/combination guard (A) onto the ﬁtting on the shaft and secure with the bolt.

CAUTION! Use the recommended blade guard. See the Technical data section.

•Fit the drive disc (B) on the output shaft.

•Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Place the blade (D), support cup (E) and support ﬂange (F) on the output shaft.

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

Adjusting the harness and brush cutter

	!	WARNING! When using a brush cutter it
	!	must always be hooked securely to the
		must always be hooked securely to the
		harness. Otherwise you will be unable to
		control the brush cutter safely and this
		can result in injury to yourself or others.
		Never use a harness with a defective
		quick release.

14 – English

Image 14

Contents 524 L 525 LST RJD 525 RS KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Quick release MufﬂerCutting equipment Cutting equipmentLocking nut Sharpening grass knifes and grass blades Trimmer headFitting the handlebar 525 RS AssemblyFitting the loop handle 524 L, 525 LST, 525 RJD Assembling and dismantling the two-piece shaft 525 RJD AssemblyAssembling the cutting equipment Fitting the trimmer guard and trimmer headDismantling Adjusting the harness and brush cutterFitting a blade guard, grass blade and grass cutter Correct height Standard harnessSpreading the load on your shoulders Correct balanceFuel Fuel safetyFuel Handling Mufﬂer gets very hot during and after FuelingMixing Use. This also applies during idling. BeStarting and stopping Starting and StoppingCheck before starting StartingFor throttle handles with a start throttle lock StoppingGeneral working instructions Basic safety rulesWorking Techniques Grass trimming with a trimmer head Grass clearing using a grass bladeBasic working techniques Cutting SweepingAdjustment of the idle speed MaintenanceBasic setting CarburettorAdjusting the start throttle speed MufﬂerTwo-piece shaft 525 RJD Cooling systemSpark plug Air ﬁlterCleaning the air ﬁlter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataTechnical Data Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Alloy Original instructions 1155734-28