Husqvarna 525 LST, 524 L, 966781601, 525 RS, 525 RJD manual Cleaning the air filter, Bevel gear

Page 26

MAINTENANCE

Cleaning the air filter

Close the choke valve by moving the choke control up.

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Clean also the inside of the filter cover by using air or a brush. Ensure that the filter is dry before refitting it.

Remove the Felt filter from the filter holder and gently brush debris from the filter. Check the rubber sealing surface. Change the filter on the rubber seal if damaged.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced. Damaged, very dirty, or fuel- soaked air filter must always be replaced.

Bevel gear

The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three-quarters full with grease. Use HUSQVARNA special grease.

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

26 – English

Page 25 Page 27
Image 26
Page 25 Page 27
Contents 524 L 525 LST RJD 525 RS KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Quick release MufflerCutting equipment Cutting equipmentLocking nut Sharpening grass knifes and grass blades Trimmer headFitting the handlebar 525 RS AssemblyFitting the loop handle 524 L, 525 LST, 525 RJD Assembling and dismantling the two-piece shaft 525 RJD AssemblyAssembling the cutting equipment Fitting the trimmer guard and trimmer headDismantling Adjusting the harness and brush cutterFitting a blade guard, grass blade and grass cutter Correct height Standard harnessSpreading the load on your shoulders Correct balanceFuel Fuel safetyFuel Handling Muffler gets very hot during and after FuelingMixing Use. This also applies during idling. BeStarting and stopping Starting and StoppingCheck before starting StartingFor throttle handles with a start throttle lock StoppingGeneral working instructions Basic safety rulesWorking Techniques Grass trimming with a trimmer head Grass clearing using a grass bladeBasic working techniques Cutting SweepingAdjustment of the idle speed MaintenanceBasic setting CarburettorAdjusting the start throttle speed MufflerTwo-piece shaft 525 RJD Cooling systemSpark plug Air filterCleaning the air filter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataTechnical Data Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Alloy Original instructions 1155734-28
Top Page Image Contents