Husqvarna 525 RS, 524 L, 525 LST Stop switch, Cutting attachment guard, Vibration damping system

Page 8

GENERAL SAFETY PRECAUTIONS

See instructions under the heading Start. Start the machine and apply full throttle. Release the throttle and check that the cutting attachment stops and remains at a standstill. If the cutting attachment rotates with the throttle in the idle position then the carburettor idle setting must be checked. See instructions under the heading Maintenance.

Stop switch

Use the stop switch to switch off the engine.

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

Cutting attachment guard

This guard is intended to prevent loose objects from being thrown towards the operator. The guard also protects the operator from accidental contact with the cutting attachment.

Check that the guard is undamaged and not cracked. Replace the guard if it has been exposed to impact or is cracked.

Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

Vibration damping system

Your machine is equipped with a vibration damping system that is designed to minimize vibration and make operation easier.

Use of incorrectly wound cord or an incorrect cutting attachment increases the level of vibration. See instructions under the heading Cutting equipment.

The machine′s vibration damping system reduces the transfer of vibration between the engine unit/cutting equipment and the machine′s handle unit.

Regularly check the vibration damping units for cracks or deformation. Check that the vibration damping element is undamaged and securely attached.

!

WARNING! Overexposure to vibration

can lead to circulatory damage or nerve

 

damage in people who have impaired

 

circulation. Contact your doctor if you

 

experience symptoms of overexposure

 

to vibration. These symptoms include

 

numbness, loss of feeling, tingling,

 

pricking, pain, loss of strength, changes

 

in skin colour or condition. These

 

symptoms normally appear in the

 

fingers, hands or wrists.

8 – English

Page 7 Page 9
Image 8
Page 7 Page 9
Contents 524 L 525 LST RJD 525 RS KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Quick release MufflerCutting equipment Cutting equipmentLocking nut Sharpening grass knifes and grass blades Trimmer headFitting the handlebar 525 RS AssemblyFitting the loop handle 524 L, 525 LST, 525 RJD Assembly Assembling the cutting equipmentAssembling and dismantling the two-piece shaft 525 RJD Fitting the trimmer guard and trimmer headDismantling Adjusting the harness and brush cutterFitting a blade guard, grass blade and grass cutter Standard harness Spreading the load on your shouldersCorrect height Correct balanceFuel Fuel safetyFuel Handling Fueling MixingMuffler gets very hot during and after Use. This also applies during idling. BeStarting and Stopping Check before startingStarting and stopping StartingFor throttle handles with a start throttle lock StoppingGeneral working instructions Basic safety rulesWorking Techniques Grass trimming with a trimmer head Grass clearing using a grass bladeBasic working techniques Cutting SweepingMaintenance Basic settingAdjustment of the idle speed CarburettorAdjusting the start throttle speed MufflerCooling system Spark plugTwo-piece shaft 525 RJD Air filterCleaning the air filter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataTechnical Data Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Alloy Original instructions 1155734-28
Top Page Image Contents