Husqvarna 525 RS Assembling the cutting equipment, Fitting the trimmer guard and trimmer head

Page 13

ASSEMBLY

Assembling the cutting equipment

•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

H

!

WARNING!

When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

H

•To dismantle, follow the instructions in the reverse order.

Assembling and dismantling the two-piece shaft (525 RJD)

Assembly

!

WARNING! Never use a cutting

attachment without an approved guard.

 

 

See the chapter on Technical data. If an

 

incorrect or faulty guard is fitted this can

 

cause serious personal injury.

Fitting the trimmer guard and trimmer head

•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (L).

B

C

A

A

•Fit the drive disc (B) on the output shaft.

•Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Loosen the coupling by turning the knob.

•Align the tab of the attachment (A) with the arrow on the coupling (B).

B

A

•Push the attachment into the coupling until the attachment snaps into place.

•Before using the unit, tighten the knob securely.

English – 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 524 L 525 LST RJD 525 RS Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system Muffler Quick releaseLocking nut Cutting equipmentCutting equipment Trimmer head Sharpening grass knifes and grass bladesFitting the loop handle 524 L, 525 LST, 525 RJD AssemblyFitting the handlebar 525 RS Assembling the cutting equipment AssemblyAssembling and dismantling the two-piece shaft 525 RJD Fitting the trimmer guard and trimmer headFitting a blade guard, grass blade and grass cutter Adjusting the harness and brush cutterDismantling Spreading the load on your shoulders Standard harnessCorrect height Correct balanceFuel Handling Fuel safetyFuel Mixing FuelingMuffler gets very hot during and after Use. This also applies during idling. BeCheck before starting Starting and StoppingStarting and stopping StartingStopping For throttle handles with a start throttle lockWorking Techniques Basic safety rulesGeneral working instructions Basic working techniques Grass clearing using a grass bladeGrass trimming with a trimmer head Sweeping CuttingBasic setting MaintenanceAdjustment of the idle speed CarburettorMuffler Adjusting the start throttle speedSpark plug Cooling systemTwo-piece shaft 525 RJD Air filterBevel gear Cleaning the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataTechnical Data Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Alloy Original instructions 1155734-28
Top Page Image Contents