Husqvarna 966781601, 524 L, 525 LST, 525 RS, 525 RJD manual Cutting, Sweeping

Page 22

WORKING TECHNIQUES

Cutting

•The trimmer is ideal for cutting grass that is difﬁcult to reach using a normal lawn mower. Keep the cord parallel to the ground when cutting. Avoid pressing the trimmer head against the ground as this can ruin the lawn and damage the tool.

•Do not allow the trimmer head to constantly come into contact with the ground during normal cutting. Constant contact of this type can cause damage and wear to the trimmer head.

Sweeping

•The fan effect of the rotating cord can be used for quick and easy clearing up. Hold the cord parallel to and above the area to be swept and move the tool to and fro.

•When cutting and sweeping you should use full throttle to obtain the best results.

IMPORTANT!

To avoid unbalance and vibrations in handles trimmer head cover need to be cleaned every time cord is reﬁlled. In addition, check other part of the head if needed to be cleaned.

22 – English

Image 22

Contents 524 L 525 LST RJD 525 RS KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutCutting attachment guard Stop switchVibration damping system Quick release MufﬂerLocking nut Cutting equipmentCutting equipment Sharpening grass knifes and grass blades Trimmer headFitting the loop handle 524 L, 525 LST, 525 RJD AssemblyFitting the handlebar 525 RS Assembling and dismantling the two-piece shaft 525 RJD AssemblyAssembling the cutting equipment Fitting the trimmer guard and trimmer headFitting a blade guard, grass blade and grass cutter Adjusting the harness and brush cutterDismantling Correct height Standard harnessSpreading the load on your shoulders Correct balanceFuel Handling Fuel safetyFuel Mufﬂer gets very hot during and after FuelingMixing Use. This also applies during idling. BeStarting and stopping Starting and StoppingCheck before starting StartingFor throttle handles with a start throttle lock StoppingWorking Techniques Basic safety rulesGeneral working instructions Basic working techniques Grass clearing using a grass bladeGrass trimming with a trimmer head Cutting SweepingAdjustment of the idle speed MaintenanceBasic setting CarburettorAdjusting the start throttle speed MufﬂerTwo-piece shaft 525 RJD Cooling systemSpark plug Air ﬁlterCleaning the air ﬁlter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataTechnical Data Super Auto Super Auto II Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x Alloy Original instructions 1155734-28