Powermatic manual 16.1.1 PM2020 Headstock Assembly Exploded View

Page 26

16.1.1PM2020 Headstock Assembly – Exploded View

26

Image 26

Contents Powermatic Part No. M-1792020Warranty and Service Warranty PeriodTable of Contents Safety warnings Introduction Specifications CapacitiesContents of shipping container UnpackingLathe should be disconnected from power during assembly AssemblyTools required for assembly Tool caddyBed extension optional accessory Shelf Style 2 Figure Shelf assemblies optionalShelf Style 1 Figure Shelf Style 3 FigureElectrical connections Single Phase OperationThree Phase Operation Extension cordsCam tightness AdjustmentsHeadstock and tailstock Movement Tool supportIndexer Centers installing/removingLive center and cone Important Remove index pin before turning on the LatheSheave and belt alignment Face plate installing/removingSpeed change Sheave/drive belt replacement Checking spindle playInspection Operating controlsOperation Turning toolsSpindle turning Stock selectionCutting techniques Roughing out Beads Face plate and bowl turning Sanding and FinishingTo Shape Outside of Bowl To Shape Interior of BowlMaintenance Do not disassemble inverter to cleanHow to use the chart Indexer positionsProbable Cause Remedy Troubleshooting the PM2020 LatheTrouble Replacement parts 16.1.1 PM2020 Headstock Assembly Exploded View 16.1.2 PM2020 Headstock Assembly Parts List Index No. Part No Description Size Qty#10-24x1-1/2 16.2.1 PM2020 Stand and Bed Assembly Exploded View 16.2.2 PM2020 Stand and Bed Assembly Parts List Bed Extension Assembly includes items 1 thru Bed Extension Assembly includes items 7 thru6295897 Offset Tool Support Pin Optional Accessories Face Plates, Tool Supports and Misc 4-8Electrical connections Electrical Remote On/Off Switch optional accessory New Sanford Road LaVergne, Tennessee