Powermatic PM2020 manual Electrical Remote On/Off Switch optional accessory

Page 35

18.0 Electrical: Remote On/Off Switch (optional accessory)

NOTE: The Lathe can only operate when both the headstock and remote switches are in the “ON” position. To mount the remote switch to your Lathe, proceed as follows.

1.Disconnect all electrical power to the Lathe.

2.Remove the two screws from the control panel. Do NOT disconnect control panel from wiring harness.

3.Run the remote switch’s wiring harness through the opening in the back of the headstock and out through the front of the headstock.

4.Connect the remote switch’s wiring harness to the back of the Push/Pull switch (refer to the electrical schematic, sect. 17.0).

5.Reinstall the control panel to the headstock. From the back of the headstock, lightly pull out any excess wire that may be inside the headstock.

6.The magnetic back on the remote switch will allow the switch to be placed anywhere on the Lathe.

7.Connect electrical power to the Lathe and resume operations.

35

Image 35

Contents Part No. M-1792020 PowermaticWarranty Period Warranty and ServiceTable of Contents Safety warnings Introduction Capacities SpecificationsUnpacking Contents of shipping containerTool caddy AssemblyTools required for assembly Lathe should be disconnected from power during assemblyBed extension optional accessory Shelf Style 3 Figure Shelf assemblies optionalShelf Style 1 Figure Shelf Style 2 FigureExtension cords Single Phase OperationThree Phase Operation Electrical connectionsTool support AdjustmentsHeadstock and tailstock Movement Cam tightnessImportant Remove index pin before turning on the Lathe Centers installing/removingLive center and cone IndexerSheave and belt alignment Face plate installing/removingSpeed change Checking spindle play Sheave/drive belt replacementTurning tools Operating controlsOperation InspectionStock selection Spindle turningCutting techniques Roughing out Beads Sanding and Finishing Face plate and bowl turningTo Shape Interior of Bowl To Shape Outside of BowlDo not disassemble inverter to clean MaintenanceIndexer positions How to use the chartProbable Cause Remedy Troubleshooting the PM2020 LatheTrouble Replacement parts 16.1.1 PM2020 Headstock Assembly Exploded View Index No. Part No Description Size Qty 16.1.2 PM2020 Headstock Assembly Parts List#10-24x1-1/2 16.2.1 PM2020 Stand and Bed Assembly Exploded View 16.2.2 PM2020 Stand and Bed Assembly Parts List Bed Extension Assembly includes items 7 thru Bed Extension Assembly includes items 1 thru6295897 Offset Tool Support Pin 4-8 Optional Accessories Face Plates, Tool Supports and MiscElectrical connections Electrical Remote On/Off Switch optional accessory New Sanford Road LaVergne, Tennessee