Powermatic manual 16.2.1 PM2020 Stand and Bed Assembly Exploded View

Page 29

16.2.1PM2020 Stand and Bed Assembly – Exploded View

29

Image 29

Contents Part No. M-1792020 PowermaticWarranty Period Warranty and ServiceTable of Contents Safety warnings Introduction Capacities SpecificationsUnpacking Contents of shipping containerTools required for assembly AssemblyLathe should be disconnected from power during assembly Tool caddyBed extension optional accessory Shelf Style 1 Figure Shelf assemblies optionalShelf Style 2 Figure Shelf Style 3 FigureThree Phase Operation Single Phase OperationElectrical connections Extension cordsHeadstock and tailstock Movement AdjustmentsCam tightness Tool supportLive center and cone Centers installing/removingIndexer Important Remove index pin before turning on the LatheSheave and belt alignment Face plate installing/removingSpeed change Checking spindle play Sheave/drive belt replacementOperation Operating controlsInspection Turning toolsStock selection Spindle turningCutting techniques Roughing out Beads Sanding and Finishing Face plate and bowl turningTo Shape Interior of Bowl To Shape Outside of BowlDo not disassemble inverter to clean MaintenanceIndexer positions How to use the chartProbable Cause Remedy Troubleshooting the PM2020 LatheTrouble Replacement parts 16.1.1 PM2020 Headstock Assembly Exploded View Index No. Part No Description Size Qty 16.1.2 PM2020 Headstock Assembly Parts List#10-24x1-1/2 16.2.1 PM2020 Stand and Bed Assembly Exploded View 16.2.2 PM2020 Stand and Bed Assembly Parts List Bed Extension Assembly includes items 7 thru Bed Extension Assembly includes items 1 thru6295897 Offset Tool Support Pin 4-8 Optional Accessories Face Plates, Tool Supports and MiscElectrical connections Electrical Remote On/Off Switch optional accessory New Sanford Road LaVergne, Tennessee