25.Use recommended accessories; improper accessories may be hazardous.
26.Keep turning tools sharp and clean for the best and safest performance, and position the tools properly in relation to the workpiece.
27.Turn off the machine before cleaning. Use a brush or compressed air to remove chips or debris — do not use your hands.
28.Do not stand on the machine. Serious injury could occur if the machine tips over.
29.Never leave the Lathe running unattended. Turn the power off and do not leave the machine until it comes to a complete stop.
30.Remove loose items and unnecessary work pieces from the area before starting the machine.
31.Check the workpiece carefully for splits, knots or other obstructions which may cause a safety risk while turning.
32.Adjust the tool support to the proper height and position for the work. Rotate the workpiece by hand to check clearance with the tool support.
33.Select the appropriate speed for the turning job at hand. Start at low speed and allow the Lathe to ramp up to operating speed.
34.Never stop a rotating workpiece with your hand.
35.If gluing up a workpiece, always use a high- quality glue of the type necessary for that particular workpiece.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly even death.
4.0Introduction
This manual is provided by Powermatic covering the safe operation and maintenance procedures for a Model PM2020 Lathe. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide consistent,
5