Powermatic PM2020 manual Unpacking, Contents of shipping container

Page 7

6.0Unpacking

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Lathe is assembled and running properly.

Compare the contents of your container with the following parts list to make sure all parts are intact. Some parts can be found in separate boxes packed around the Lathe. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

6.1Contents of shipping container

1Lathe Bed, with Headstock, Tailstock, & Tool Support Base – (A)

2Leg Assemblies – (B)

1 Guard – (C)

1Tool Support, 14” – (D)

1Face Plate, 3” – (E)

1Live Center – (F)

1Spur Center, 1” – (G)

1Index Pin – (H)

1Live Center Pin – (J)

1Knockout Rod – (K)

1Face Plate Wrench – (L)

1Tool Caddy – (M)

4Levelers – (N)

10Socket Hd. Cap Screws, 3/8” x 1-1/4” – (O)

10Lock Washers, 3/8” – (P)

8Flat Washers, 3/8” – (R)

1Owner's Manual (not shown)

1Warranty Card (not shown)

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

7

Image 7

Contents Part No. M-1792020 PowermaticWarranty Period Warranty and ServiceTable of Contents Safety warnings Introduction Capacities SpecificationsUnpacking Contents of shipping containerTool caddy AssemblyTools required for assembly Lathe should be disconnected from power during assemblyBed extension optional accessory Shelf Style 3 Figure Shelf assemblies optionalShelf Style 1 Figure Shelf Style 2 FigureExtension cords Single Phase OperationThree Phase Operation Electrical connectionsTool support AdjustmentsHeadstock and tailstock Movement Cam tightnessImportant Remove index pin before turning on the Lathe Centers installing/removingLive center and cone IndexerSpeed change Face plate installing/removingSheave and belt alignment Checking spindle play Sheave/drive belt replacementTurning tools Operating controlsOperation InspectionStock selection Spindle turningCutting techniques Roughing out Beads Sanding and Finishing Face plate and bowl turningTo Shape Interior of Bowl To Shape Outside of BowlDo not disassemble inverter to clean MaintenanceIndexer positions How to use the chartTrouble Troubleshooting the PM2020 LatheProbable Cause Remedy Replacement parts 16.1.1 PM2020 Headstock Assembly Exploded View Index No. Part No Description Size Qty 16.1.2 PM2020 Headstock Assembly Parts List#10-24x1-1/2 16.2.1 PM2020 Stand and Bed Assembly Exploded View 16.2.2 PM2020 Stand and Bed Assembly Parts List Bed Extension Assembly includes items 7 thru Bed Extension Assembly includes items 1 thru6295897 Offset Tool Support Pin 4-8 Optional Accessories Face Plates, Tool Supports and MiscElectrical connections Electrical Remote On/Off Switch optional accessory New Sanford Road LaVergne, Tennessee