Partner Tech P11577H To Level Mower, FRONT-TO-BACK Adjustment, Visual SIDE-TO-SIDE Adjustment

Page 60

6

Fig. 1

A

3 7 4 2 0

024 73

02948

Fig. 2

 

 

02966

A

A

To Level Mower

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the ap- pearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT

1.With all tires properly inflated and if your lawn appears un- evenly cut, determine which side of mower is cutting lower.

2.With a 3/4" or adjustable wrench, turn lift link adjustment nut (A) to the left to lower the mower, or, to the right to raise the mower (Fig. 1).

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

3.Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT

1.With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blade is sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

2.Raise mower to its highest position.

3.At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides (Fig. 2).

4.If adjustment is necessary, see step 2 in Visual Adjust- ment instructions above.

5.Recheck measurements, adjust if necessary until both

sides are equal.

Fig. 3

 

 

02548

B

B

Fig. 4

B

A

B

3

47

02

02473

02950

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 3/8" lower than the rear tip when the mower is in its highest position.

CAUTION: Blade is sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

Raise mower to highest position.

Position blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade (Fig. 3).

If front tip of blade is not 1/8" to 3/8" lower than the rear tip, go to the front of tractor.

With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

With a 3/4" or adjustable wrench, turn front link adjustment nut (B) clockwise (ltighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower (Fig. 4).

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 3/8" lower than the rear tip.

Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

60

Image 60
Contents P11577H Page Safety Rules TrainingII. Preparation III. OperationIV. Maintenance and Storage Sicherheitsvorschriften SchulungII. Vorbereitung III. BetriebIV. Wartung UND Lagerung Règles de Sécurité Précautions D’UTILISATIONII. Préparation III. UtilisationIV. Entretien ET Entreposage Reglas De Seguridad InstrucciónII. Preparación III. OperaciónIV. Mantenimiento Y Almacenamiento Norme Antinfortunistiche Addestramento ALL’USOIII. Funzionamento II. PreparazioneIV. Manutenzione E Periodi DI INATTIVITA’ Veiligheidsregels II. VoorbereidingIII. Bediening Gebruik de trekker niet op hellingen van meer danIV. Onderhoud EN Opslag 84/6.59190 Complies with 2006/42/ECReverse Directive for Safety Züglich MIT WAS Explosive Gase SER AusspülenSofort Ärztliche Hilfe AufsuchenVolant DE Direction Steering WheelLenkrad Volante DE DirecciónSitz SiègeAsiento SedileHinweis RemarqueNota Install Battery Einbau DER Batterie Installazione Della BatteriaAccu Installeren Mise EN Place DE LA Batterie02604 Page Emplacement des commandes ComandiUbicación de los mandos De plaats van de bedieningsorganen Commande des gaz et starter Gas-und kaltstarthebelMandos del acelerador y del estrangulador Comando gas/chokeLevier de commande de la transmission hydrostatique Clutch/Brake PedalMotion control lever Ein- und Ausschalten des AntriebesCommande dembrayage et de débrayage du carter de coupe Connection/disconnection of the cutting unitEin und Ausschalten des Mähaggregats Acoplamiento y desacoplamiento del equipo de corteQuick lifting/lowering of the cutting unit Schnelles Heben und Senken des MähaggregatsRelevage et abaissement du carter de coupe Elevación/descenso rápidos del equipo de corteIgnition Lock ZündschloßClé de contact et de démarrage Cerradura de encendidoParking brake FeststellbremseFrein de stationnement Freno de estacionamientoFree-wheel Control Lever Ein und Ausschalten des FreilaufesBlocage et déblocage de la roue libre AcoplamientoyDesacoplamientodeRuedaLibreFilling up Reposición de combustibleTanken Plein de carburantOil level ÖlstandNiveau d’huile Nivel de aceiteDriving . Betrieb . Conduite . Conducción Guida . Rijden Ne pas faire tourner le démarreur pendant plus de 5 secondes Driving BetriebConduite ConducciónReverse Operation System ROS Rückwärtsgangsystem ROSSécurité Marche Arrière ROS Sistema de Funcionamiento Atrás ROSSistema Per Operazioni In Retromarcia ROS Systeem Voor Achteruit ROSCutting tips Ratschläge zum RasenmähenConseils pour la tonte Consejos para el corteConsigli per il taglio dell’erba MaaitipsIMPORTANT! Cold Starting for Hydro IMPORTANTE! Empieso EN Frío Para HIDROS- TáticoATTENZIONE! Avviamento a Freddo PER Trasmission BELANGRIJK! Loud Starten Voor HydroPurgar LA Transmisión Spurgo Della TrasmissioneTransmissie Ontluchten Su tractor esta ahora dispuesto para la operación normalAdvertencia Advertencia WarnungPericolo WaarschuwingAdvertencia Engine hood MotorhaubeCapot moteur Cubierta del motorMaintenance WartungEntretien Warnung QuetschkantenMantenimiento ManutenzioneOnderhoud Para Cambiar EL Aceite To Change OILPER Cambiare L’OLIO Ölwechsel DurchführenService Record WartungsnachweisSchema Dentretien Informe DE ServicioService Aantekeningen Dati DI ServizioOperator Presence System and Reverse Opera- tion System ROS Fahrer-Anwesenheitssystem und Rückwärts- gangsystem ROSControl Sistema Presencia Operador Control Sistema DE Funcionamiento Atrás ROSControllo DEL Sistema DI Presenza Operatore Controllo DEL Sistema PER Operazioni in RE- Tromarcia ROSBlades MesserbalkenLames Cuchillas LameMessen PL Q To Remove MowerEntfernen Des Mähers Pour Démonter La FaucheusePL QD To Replace Mower Drive Belt Austauschen des Antriebsriemens des MähersSustituir la correa de transmisión cortacésped Pour remplacer la courroie de transmissionSostituzione della cinghia di trasmissione del rasaerba De aandrijfriem van de maaiunit vervangenFRONT-TO-BACK Adjustment Visual SIDE-TO-SIDE AdjustmentPrecision SIDE-TO-SIDE Adjustment To Level MowerAusnivellieren des Mähers Visuelle Justierung AN Beiden SeitenGenaue justierung an beiden seiten Gleich sindPour mettre la tondeuse à niveau Réglage Visuel BilatéralRéglage Bilatéral DE Précision Réglage D’AVANT EN ArrièreNivelar el cortacésped Ajuste Visual DE Lado a LadoAjuste DE Precisión DE Lado a Lado Ajuste DE LA Parte Delantera a LA TraseraLivellamento del rasaerba Regolazione Visiva LATO-LATORegolazione DI Precisione LATO-LATO Regolazione DAVANTI-DIETRODe maaiunit nivelleren Beide Kanten OP HET OOG UitlijnenPRECISIE-AFSTELLING BAN Beide Kanten BAN DE Maaiunit Afstelling BOOR-EN AchterzijdeReplacement of drive belt Remplacement de la courroie dentraînementAuswechsein des Treibriemens Cambio de correa propulsoraTransaxle Cooling TRANSACHSEN-KÜHLUNGRefroidissement DE LA Transmission Enfriamiento DEL TransejeTransaxle Motion Control Lever Neutral Adjustment Reglage DU Levier DE LA Commande D’AVANCEMENTEinstellung DES Steuerknüppels DES SchaltgetriebesPage WASCHANLAGEN-ÖFFNUNG DER Abdeckung Deck Washout PortPort DE Lavage DU Châssis Boca DE Lavado DE LA PlataformaDekreinigingspoort Apertura DI Lavaggio DEL PiattoTroubleshooting . Störungssuche Recherche des pannes . Búsqueda de averías Ricerca guasti . Het localiseren van fouten Service Storage . Aufbewahrung . Remisage . ConservaciónEntretien et réparations ServicioRismessaggio . Stallen ServizioPage Page 07.12.10 JA