4.If an air compressor is available, blow out the system by applying compressed air to the Water Inlet (see Fig. 10).

Pointer Adjustment

1.Lower the front pointer assembly.

Adjust the pointer rod (1) by loosening the lock knob (2).

Once the pointer rod is set to the cut line, tighten the lock knob.

2.Adjust the rear pointer to the cut line:

Loosen the lock bolt, position the pointer rod, and tighten the lock bolt.

3.To raise the front pointer assembly, pull back and up on the pointer cable (3).

Secure the pointer assembly in the desired raised position by locking the cable between the jaws of the cam cleat (5).

6

5

4

3

2

1

Fig. 15 — Pointer Adjustment

34

Page 34
Image 34
Multiquip SP-6457 TD operation manual Pointer Adjustment