Multiquip SP-6457 TD operation manual Specifications

SPECIFICATIONS

Engine	57 HP Turbocharged Deutz Diesel, direct injection, air/oil cooling, oil filter and
	above-frame remote oil drain.
Engine Air Cleaner	4-Stage air filtration, pre-cleaner plus cartridge element and safety element.
Fuel Tank	10 Gallon clear-molded plastic fuel tank with sight gauge, central drain and
	shutoff valve.
	Fully enclosed transmission, bearings and shaft, oil bath lubrication with cooled
	and filtered oil circulation system, 4 protected shaft seals, 2-3/8” diameter blade
Blade Shaft Assembly	shaft, rack & pinion shifting, positive shift lock, oil sight gauge, magnetic drain
	plug, easy serviceability, remote protected oil fill and vent, blade usable on either
	side of saw, taper lock blade collar attachment, standard blade shaft tachometer,
	ratios of 1:1, 1.34:1, 1.7:1, and 2.02:1
Blade Collars	Plated quick-disconnect, taper lock attachment, 5.5” diam., 24 water spray ports.
Blade Flushing	Minimum water usage system, evenly distributed across the blade, panel-
	mounted flow control.
Blade Range	14” to 48”.
Max Cut Depth	21”.
Blade Guard	Extra heavy design, slip-on type with double lip seal and quick disconnect water
	hose, two handles.
Blade Shaft Drive Belt	Dual 5--Groove premium quality Goodyear HY-T Wedge Torque Team belts.
Blade Control	12-Volt hydraulic raise/lower system, 3 blade plunge speeds, fast and slow blade
	plunge speed buttons on joystick, raise button on joystick, one-hand control.
Blade Depth Stop	Positive, heavy-duty hydraulically controlled depth stop.
Balance	Front steer.
Handlebars	3-Position adjustable angle, storage position, quick locks.
Front Wheels	8” x 3”, precision sealed bearings in each wheel with extra end seals and seal
	protectors, no grease points.
Rear Wheels	12” x 3”.
Drive System	Hydrostatic powered transaxle with infinite speed control, joystick control, remote
	oil filter and up to 300 feet per minute travel speed. Locked axle drive.
Engine Controls	Twist-lock throttle, backlit tachometer with hour meter, voltmeter, oil pressure
	gauge and 3-position ignition switch.
Battery	12-Volt, group 75, 1000 cold cranking amps.
Front Pointer	Heavy gauge steel, 6” pointer wheel and plastic-coated tether.
Rear Pointer	Standard, adjustable.
Hardware	Grade 8 fasteners throughout.
Tools	15/16” Blade wrench.
Dimensions	L= 47-1/2” with handlebars stored, W = 32” w/o blade collars, H= 44” with front
	pointer up.
Weight	1,700 Pounds, with oil but no fuel.
Serviceability	Spin-on oil filters, lubrication points, lube every 50 hours.

66