Water Supply and Control | Multiquip SP-6457 TD specs

Water Supply and Control

CAUTION

§To prevent damage to the impeller of a belt driven water pump, do not run the engine with the water pump switch on, unless the water supply is connected and water is flowing.

§When storing the saw during freezing weather, blow out the water lines to prevent damage to the water delivery system.

1.Connect the water supply hose to the water inlet (garden hose) fitting (1) on the left side of the saw.

2.Verify that the water hose on the saw is connected to the Blade Guard (5) and that the water tubes are pointed into both Blade Collars.

3.The yellow lever (4) on left side of the control panel regulates water flow volume. The other lever (3) turns the water On and Off.

4.If the saw is equipped with an optional water pump, the ON/OFF switch (2) is on the control panel next to the water flow control valve.

!

NOTE

Because of the water delivery efficiency of the 24-port blade collars, your saw will use less water for blade lubrication than other water deliver systems.

	3
2	4
2
	5
1

Fig. 10 — The Water Supply System

28

Image 28

Multiquip SP-6457 TD operation manual Water Supply and Control, Water Supply System

Contents

SP-6457 TD Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard General Safety Warnings Rules for Safe OperationPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Serial Tag Model no SPEC. no Serial no Engine Serial Operation Before Starting Engine Power, Cutting Power & Sheave Size Blade Shaft Ratios 18612 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the Blade Stacking Blades for Wide Cuts Blade Stacking Installing and Removing the Blade Guard Installing the Blade Guard Blade Guard Water Supply Installing the Collar Guard Collar Guard, Installed Water Supply and Control Water Supply System Control Panel ON-OFF Handlebars Handlebar Positions Use Fueling the Saw Starting and Stopping The Engine Restarting After Running Out of Fuel Cold Weather Operation Glow PlugsBlock Heaters Draining the Water System Pointer Adjustment Pointer Adjustment Raise Lower Controls Joystick Handle Controls Setting the Depth Indicator Setting the Depth Stop Drive System Drive System Controls Transaxle Transaxle Speed Blade Shaft 4-Speed Blade Shaft Shifting Gears Gear Shift Components Transportation Tie-downs and Lift Point Night LightTie-downs Lift Point Lift Point Maintenance Removable Guards and Access Panels Belts and Pulleys Belt Tension Adjusting Blade Shaft Drive Belt Tension Engine Mount Lock Bolts Replacing the Blade Shaft Belt Replacing the Jackshaft Belt Rotary Belt Tensioner Do not OVER-TIGHTEN Blade Shaft Maintenance Blade Shaft Replacement Blade Collar Removal/Installation Removing the Inner Blade Collar Installing the Inner Blade Collar Installing the Inner Blade Collar Inner Collar Blade Shaft Maximum Cut Depth Adjustment Circuit Breakers Lubrication Air and Oil Filter Chart Engine PTO Drive Maintenance Attaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive Sheave/Bearing Assembly Re-Assembling the PTO Drive Replacing the Battery Engine Rotated Forward to Remove the Battery Raise/Lower Troubleshooting Raise-Lower System Joystick Tension Adjustment Joystick Adjustment Hydraulic System Maintenance Routine Maintenance Draining & Filling the Hydraulic System To drain the hydraulic system To fill the hydraulic system Bleeding the Depth Stop Cylinder Bleeding the Depth Stop Cylinder Drive Wheel Alignment Drive Wheel Alignment Pivot Side Adjustment Side Specifications Dimensions Electric Diagram Www multiquip.com