Rotary Belt Tensioner
The Rotary Belt Tensioner system uses a
nut to set belt tension by positioning an arm between the Tensioner Pulley and
the Tensioner Base. Ridges on the Base mark the amount of tension.
1.Loosen the Bolt Head.
2.Rotate the Tensioner Nut clockwise until the desired belt tension is achieved.
3.Tighten the Bolt Head.
4.DO NOT OVER-TIGHTEN.
Engine Sheave
2 | 1 |
|
JackShaft Pulley
3 
Tensioner Pulley
Tensioner Nut— | 4 | 5 |
| ||
Tensioner Bolt Head is |
| Tensioner Base |
on opposite side |
| |
|
|
Fig. 29 — The JackShaft Belt and Rotary Belt Tensioner System
47
