Installing the Collar Guard | Multiquip SP-6457 TD specification

Installing the Collar Guard

The Collar Guard protects unused Blade Collars.

1.Slide the Collar Guard (1) onto the Guard Mounting Tab on the frame.

2.Verify that the unused Blade Collar (2) is secured to the Blade Shaft, by tightening the mounting bolt (3).

1 – Collar Guard

2 – Blade Collar

3 – Mounting Bolt

Fig. 9 — The Collar Guard, Installed

27

Image 27

Multiquip SP-6457 TD operation manual Installing the Collar Guard, Collar Guard, Installed

Contents

SP-6457 TD Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard Rules for Safe Operation General Safety WarningsPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Model no SPEC. no Serial no Serial Tag Engine Serial Before Starting Operation Blade Shaft Ratios Engine Power, Cutting Power & Sheave Size 18612 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the Blade Blade Stacking Stacking Blades for Wide Cuts Installing the Blade Guard Installing and Removing the Blade Guard Blade Guard Water Supply Collar Guard, Installed Installing the Collar Guard Water Supply System Water Supply and Control ON-OFF Control Panel Handlebar Positions Handlebars Fueling the Saw Use Restarting After Running Out of Fuel Starting and Stopping The Engine Draining the Water System Cold Weather OperationGlow Plugs Block Heaters Pointer Adjustment Pointer Adjustment Joystick Handle Controls Raise Lower Controls Setting the Depth Stop Setting the Depth Indicator Drive System Controls Drive System Transaxle Transaxle 4-Speed Blade Shaft Speed Blade Shaft Gear Shift Components Shifting Gears Night Light Transportation Tie-downs and Lift PointTie-downs Lift Point Lift Point Removable Guards and Access Panels Maintenance Belt Tension Belts and Pulleys Engine Mount Lock Bolts Adjusting Blade Shaft Drive Belt Tension Replacing the Jackshaft Belt Replacing the Blade Shaft Belt Do not OVER-TIGHTEN Rotary Belt Tensioner Blade Shaft Replacement Blade Shaft Maintenance Removing the Inner Blade Collar Blade Collar Removal/Installation Installing the Inner Blade Collar Installing the Inner Blade Collar Inner Collar Blade Shaft Circuit Breakers Maximum Cut Depth Adjustment Lubrication Engine Air and Oil Filter Chart Attaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive Maintenance Re-Assembling the PTO Drive PTO Drive Sheave/Bearing Assembly Engine Rotated Forward to Remove the Battery Replacing the Battery Raise-Lower System Raise/Lower Troubleshooting Joystick Adjustment Joystick Tension Adjustment Routine Maintenance Hydraulic System Maintenance To drain the hydraulic system Draining & Filling the Hydraulic System To fill the hydraulic system Bleeding the Depth Stop Cylinder Bleeding the Depth Stop Cylinder Drive Wheel Alignment Drive Wheel Alignment Pivot Side Adjustment Side Specifications Dimensions Electric Diagram Www multiquip.com