General Safety Precautions
CAUTION
§ALWAYS read, understand, and follow procedures in the Operator’s Manual before attempting to operate the equipment.
§Be sure the operator is familiar with proper safety precautions and operating techniques before using the saw.
§Make sure the operating area is clear before starting the engine.
§Maintain this equipment in a safe operating condition at all times.
§Keep the saw clean. It will work better and last longer.
§Use proper blades and follow the blade manufacturer’s recommendations. Match blade rpm (Blade Shaft rpm) to recommended blade surface feet per minute (SFPM).
§Tighten the 5/8”
§Turn engine OFF prior to fueling the saw.
§Start engine with the joystick in NEUTRAL to prevent unexpected saw movement.
§Do not leave saw unattended while engine is running.
§Do not start engine on a sloping surface to prevent unexpected loss of control.
§Do not park or leave saw unattended on a slope - the saw can roll when the engine is OFF. Block the unit when leaving.
§If the saw must be parked on a slope, turn it across the angle of the slope, to prevent accidental downhill movement.
§Always store equipment properly when not being used. Equipment should be stored in a clean, dry location out of the reach of children. When storing the saw in freezing weather, blow out water lines to prevent damage to components in the water delivery system.
§Prior to service, level the frame surface.
§Do not over tighten the Blade Shaft drive belt.
§Turn on water flow prior to starting the engine, to prevent damage to the impeller of a
§Don’t pollute! Waste oils and other chemicals must be disposed of in a manner consistent with local and state environmental protection regulations.
13