Belts and Pulleys, Belt Tension | Multiquip SP-6457 TD guide

Belts and Pulleys

Belt

Qty Part Number

Blade Shaft Drive Belt (5)	2	Part # 520009

Jackshaft Belt (3)	1	Part # 521012

Transaxle Drive Belt (2)	1	Part# 521004

		Part# 521006
Water Pump Option Belts	1	Part# 521008
		JackShaft
2	1
2
		5
3
	4
Belt Tensioner Pulley

Fig. 26 — Belt Locations

V-Belt Tension

Ideal V-Belt tension is the lowest tension at which the belt will not slip under peak load conditions. Check V-Belt tension frequently during the first 24-48 hours of run-in operation.

44

Image 44

Multiquip SP-6457 TD operation manual Belts and Pulleys, Belt Tension

Contents

SP-6457 TD Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard General Safety Warnings Rules for Safe OperationPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Serial Tag Model no SPEC. no Serial no Engine Serial Operation Before Starting Engine Power, Cutting Power & Sheave Size Blade Shaft Ratios 18612 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the Blade Stacking Blades for Wide Cuts Blade Stacking Installing and Removing the Blade Guard Installing the Blade Guard Blade Guard Water Supply Installing the Collar Guard Collar Guard, Installed Water Supply and Control Water Supply System Control Panel ON-OFF Handlebars Handlebar Positions Use Fueling the Saw Starting and Stopping The Engine Restarting After Running Out of Fuel Cold Weather Operation Glow PlugsBlock Heaters Draining the Water System Pointer Adjustment Pointer Adjustment Raise Lower Controls Joystick Handle Controls Setting the Depth Indicator Setting the Depth Stop Drive System Drive System Controls Transaxle Transaxle Speed Blade Shaft 4-Speed Blade Shaft Shifting Gears Gear Shift Components Tie-downs Night LightTransportation Tie-downs and Lift Point Lift Point Lift Point Maintenance Removable Guards and Access Panels Belts and Pulleys Belt Tension Adjusting Blade Shaft Drive Belt Tension Engine Mount Lock Bolts Replacing the Blade Shaft Belt Replacing the Jackshaft Belt Rotary Belt Tensioner Do not OVER-TIGHTEN Blade Shaft Maintenance Blade Shaft Replacement Blade Collar Removal/Installation Removing the Inner Blade Collar Installing the Inner Blade Collar Installing the Inner Blade Collar Inner Collar Blade Shaft Maximum Cut Depth Adjustment Circuit Breakers Lubrication Air and Oil Filter Chart Engine PTO Drive Maintenance Attaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive Sheave/Bearing Assembly Re-Assembling the PTO Drive Replacing the Battery Engine Rotated Forward to Remove the Battery Raise/Lower Troubleshooting Raise-Lower System Joystick Tension Adjustment Joystick Adjustment Hydraulic System Maintenance Routine Maintenance Draining & Filling the Hydraulic System To drain the hydraulic system To fill the hydraulic system Bleeding the Depth Stop Cylinder Bleeding the Depth Stop Cylinder Drive Wheel Alignment Drive Wheel Alignment Pivot Side Adjustment Side Specifications Dimensions Electric Diagram Www multiquip.com