Replacing the Battery | Multiquip SP-6457 TD specification

Replacing the Battery

This saw uses a Group 75, 12-Volt, 1000 cold cranking amp battery. To replace

the battery:

1.Remove Engine Guard and Upper Belt Guard.

2.Loosen the Rotary Tensioner and remove the Transaxle Belt.

3.Loosen the two Engine Mount Lock Bolts and the Single Point Belt Tension Bolt.

	Engine Mount	Jam Nut	Single Point Belt
	Engine Mount	Jam Nut	Tension Bolt
	Lock Bolt		Tension Bolt
	Lock Bolt
	Access Panel

Fig. 39 — Engine Mount Lock Bolts Single Point Belt Tension Bolt – from Belt Tension

4.Tilt the saw down and roll the engine as far forward as possible, to create the maximum access opening. See figure 40.

5.Disconnect the battery cables, Positive first, to avoid arcing.

6.Remove the forward battery tie-down clip.

7.Carefully roll the battery up and maneuver it out through the space between the Control Console and the Engine.

8.To replace the battery, repeat steps 1-5 in reverse order

Fig. 40 — Engine Rotated Forward to Remove the Battery

57

Image 57

Multiquip SP-6457 TD operation manual Replacing the Battery, Engine Rotated Forward to Remove the Battery

Contents

SP-6457 TD Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard Rules for Safe Operation General Safety WarningsPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Model no SPEC. no Serial no Serial Tag Engine Serial Before Starting Operation Blade Shaft Ratios Engine Power, Cutting Power & Sheave Size 18612 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the Blade Blade Stacking Stacking Blades for Wide Cuts Installing the Blade Guard Installing and Removing the Blade Guard Blade Guard Water Supply Collar Guard, Installed Installing the Collar Guard Water Supply System Water Supply and Control ON-OFF Control Panel Handlebar Positions Handlebars Fueling the Saw Use Restarting After Running Out of Fuel Starting and Stopping The Engine Glow Plugs Cold Weather OperationBlock Heaters Draining the Water System Pointer Adjustment Pointer Adjustment Joystick Handle Controls Raise Lower Controls Setting the Depth Stop Setting the Depth Indicator Drive System Controls Drive System Transaxle Transaxle 4-Speed Blade Shaft Speed Blade Shaft Gear Shift Components Shifting Gears Night Light Transportation Tie-downs and Lift PointTie-downs Lift Point Lift Point Removable Guards and Access Panels Maintenance Belt Tension Belts and Pulleys Engine Mount Lock Bolts Adjusting Blade Shaft Drive Belt Tension Replacing the Jackshaft Belt Replacing the Blade Shaft Belt Do not OVER-TIGHTEN Rotary Belt Tensioner Blade Shaft Replacement Blade Shaft Maintenance Removing the Inner Blade Collar Blade Collar Removal/Installation Installing the Inner Blade Collar Installing the Inner Blade Collar Inner Collar Blade Shaft Circuit Breakers Maximum Cut Depth Adjustment Lubrication Engine Air and Oil Filter Chart Attaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive Maintenance Re-Assembling the PTO Drive PTO Drive Sheave/Bearing Assembly Engine Rotated Forward to Remove the Battery Replacing the Battery Raise-Lower System Raise/Lower Troubleshooting Joystick Adjustment Joystick Tension Adjustment Routine Maintenance Hydraulic System Maintenance To drain the hydraulic system Draining & Filling the Hydraulic System To fill the hydraulic system Bleeding the Depth Stop Cylinder Bleeding the Depth Stop Cylinder Drive Wheel Alignment Drive Wheel Alignment Pivot Side Adjustment Side Specifications Dimensions Electric Diagram Www multiquip.com