12
6 troubleshooting
WARNING: Unplug blower/vac from power source before servicing. Severe injury or death could occur from fire, electrical shock, or rotating impeller.
Note: For additional help, visit our technical ser vice web site at www.desatech.com.
OBSERVED FAULT | POSSIBLE CAUSE | REMEDY | ||
Motordoesnotrunwhenyouturnon/off | 1. | Bottom inlet cover or vacuum tube | 1. | Check inlet cover or vacuum tube |
switch low or high |
| adapter not locked into place |
| adapter for proper installation (see |
|
|
|
| blower/vac assembly, page 4) |
| 2. | Extension cord connection is loose | 2. | Check cord connection at electrical |
|
|
|
| outlet and at rear of blower/vac |
Motor runs, but vacuum will not pick | 1. | Clogged vacuum tube or impeller | 1. | Follow steps under Removing |
up debris |
|
|
| Clogged Debris from the Impeller, |
|
|
|
| page 10 |
| 2. | Vacuum bag full | 2. | Empty vacuum bag (see Emptying |
|
|
|
| the Vacuum Bag, page 10 |
Blower/vac vibrates excessively and/or | Clogged vacuum tube or impeller | Follow steps under Removing Clogged | ||
makes abnormal noises |
|
| Debris from the Impeller, page 10 | |
Technical Service
You may have further questions about assembling,operating,or maintaining this blower/vac.If so,you can visit ourTechnical Service web site at www.desatech.com or contact ourTechnical Service Department at
DESA Power Tools
ATTN: Technical Service Specialty Products
P.O. Box 90004
Bowling Green, KY
When contacting DESA Power Tools, have ready
•Your Name
•Your Address
•Your Phone Number
•Model Number of Product
•Date of Purchase (include copy of receipt for written requests)