Remington BV12200A, BV1220DAT owner manual Blower/vac assembly, Assembling Blower

3 blower/vac assembly

Assembling Blower

WARNING: To Reduce The Risk of Personal Injury or Electric Shock – Disconnect from power source before assembling or changing attachments.

Follow the steps below to assemble the blower. IMPORTANT: The blower will not run unless the bottom inlet cover is locked into place.

1.Slide the blower tube onto outlet on front of blower/vac housing (see Fig- ure 3-1). Securely connect the draw latch to the blower tube (see Figure 3-2).

2.Position front of bottom inlet cover over motor housing hook (see Figure 3-3).

3.Pivot bottom inlet cover to bottom of blower/vac housing. Slightly press locking lever on bottom inlet cover to allow cover to lock into place (see Figures 3-4 and 3-5).

1

Figure 3-1: Sliding blower tube into place

Figure 3-2: Connect draw latch to blower tube

4

Figure 3-4: Pivoting bottom inlet cover to blower/vac housing

Figure 3-5: Pressing locking lever

3 2

Figure 3-3: Attaching bottom inlet cover to motor housing hook

120133