R
VOYAGEUR GRAND Wood Insert
E. Securing Appliance to Stove Pipe/Liner
1.Once you have the appliance in place and secured, remove the tube channel assembly, baffle board and ceramic blanket. Detailed instructions are found on pages 23 and 24.
2.Reach up through the flue opening and grab the attach- ment bar and pull down inside flue opening. Figure 41.1.
3.Insert the 5/16 bolts inside the cast flue and through the chimney mounting bar. Securely tighten the nuts. Fas- teners are provided.
4.
5/16 Bolts |
Attachment |
Bar |
5/16 Nuts |
Figure 41.1
F. Standard Surround & Trim Kit Installation
Standard Size: 43 in. W x 31 in. H
Large Size: 51 in. W x 34 in. H
1.Lay surround face down on a protected surface to pre- vent scratching.
2.Using a 4 to 6 inches long Phillips head screw driver attach the side surrounds to the top surround using (2)
#8 sheet metal screws on each side provided with the kit. Figure 41.2.
3.Lay the trim face down and place the corner brackets into position.
4.Using a standard flat screw driver tighten the corner brackets. Figure 41.3.
5.Slide the assembled trim set over the surround set. and then over the appliance matching the mounting tabs on the side pieces with the slots on the appliance. Figure 41.2.
6.Align the 2 screws in the top surround piece to the 2 alignment holes on the appliance top. Secure in place. Figure 41.2.
7.Use the strain relief in the surround side for blower cord installation and use the cover plug to insert into the hole where the blower cord is not installed.
Secure 2 Sides to Top
Secure to
Firebox Face
Mounting Tabs
Slide into Slots on Firebox Face
Strain Relief for
Blower Cord and Cover Plug for hole in each side
Figure 41.2
Corner Brackets |
Figure 41.3
September 25, 2012 | Page 41 |